Bolted Stringer Pedestal for ConCore & All Steel Access Floor Panels

Pedestal Assembly

Assembly up to 36" FFH shall provide a 6,000 lb. axial load without permanent deformation
Assembly shall provide a 2" total adjustment with a floor height of 7" or greater
Standard finished floor heights of 6" to 36" For other finished floor heights please contact the Tate Technical Hotline 800 231 7788. For floor heights and seismic concerns please contact B&OI.
Overturning moment of 1,000 in./lbs. when Tate recommend pedestal adhesive is utilized Pedestal Head
8 ga. die-formed hot dipped galvanized steel pedestal head and projection welded stud with adjustment nut
Head and installed stringers shall provide full perimeter edge support for panel
Stringers shall be attached with 1/4"- 20 flat-head screws
Pedestal head shall be tapped for engagement of stringer screws
Steel stud shall be 3/4"- 10 UNC roll formed
Nut shall be 3/4"- 10 UNC and hot dipped galvanized
Stud shall provide an anti-rotation feature when engaged with the pedestal base assembly

Heavy duty roll formed steel stringer will withstand 450 lb. mid-span load
Hot dipped galvanized stringer construction to prevent corrosion
Stringer shall be 11/4" deep x 3/4" wide and have a factory applied conductive coating
Stringer grid pattern shall be 2' x 2', 2' x 4' or 4' x 4'

• Perimeter pedestal shall provide support for panels around columns and at walls